TurnNBurn drill adapter for semi trailers

A landing gear drill adapter attaches to the landing gear shaft and lets you use a cordless drill instead of hand cranking. It helps you raise and lower trailer legs faster and with less strain.

TurnNBurn is a drill-powered landing gear adapter. You attach it to the landing gear shaft, then use a cordless drill to raise or lower the trailer legs faster than manual cranking. It helps you save time and reduce strain during everyday trailer work.

Use a standard cordless drill driver with at least 18 volts. It gives you smoother, more controlled power for raising and lowering landing gear. An impact driver is not recommended because it is designed for fastener work, not this kind of operation.

No modifications are needed—just attach it to the landing gear shaft, and you’re ready to go.

Yes. TurnNBurn helps you raise and lower landing gear with less manual effort, which can save time and reduce physical strain. That makes everyday drop-and-hook tasks easier and more efficient for you and your team.

The main difference is the type, capacity, and jack system of the trailer they are designed to operate.A trailer jack drill adapter is commonly used on light-duty and some medium-duty trailers, including utility trailers, cargo trailers, boat trailers, equipment trailers, and some travel trailers. These trailers may use either top-crank or side-crank trailer jacks, depending on the jack design. Trailer jack adapters are generally intended for lower-capacity jack systems and may connect to a 1-inch shaft or a smaller crankshaft commonly found on certain light- and medium-duty trailer jacks.A landing gear drill adapter is typically designed for heavy-duty and some medium-duty trailers, including semi-trailer dry vans, refrigerated trailers (reefers), flatbeds, container chassis, and some equipment trailers equipped with landing gear. These landing gear systems use a side-crank configuration and commonly feature a 1-inch input/crankshaft. They are engineered to support the substantially greater loads associated with commercial trailer operations.Both trailer jack drill adapters and landing gear drill adapters allow a cordless drill to replace repetitive manual cranking, but the two are not necessarily interchangeable. The correct adapter depends on the trailer's weight class, jack or landing gear design, crank location, shaft size, and load capacity.TurnNBurn® is specifically designed as a landing gear drill adapter for medium and heavy-duty trailers equipped with compatible 1-inch landing gear crankshafts.

TurnNBurn fits trailers with a standard 1-inch landing gear shaft. To confirm compatibility, remove the crank handle and measure the shaft diameter. If it measures 1 inch, you should be good to go, and no trailer modification is needed.

Absolutely! The TurnNBurn Adapter is built to endure extreme temperatures and moisture, ensuring reliability in any weather.

The TurnNBurn Adapter can reduce the time spent on raising and lowering landing gear by 50% or more, making your operations faster and more efficient.

Absolutely, the TurnNBurn Adapter is constructed from high-quality materials to endure daily heavy-duty trucking operations.

Remove the landing-gear crank handle Measure the shaft diameter If it measures 1 inch, TurnNBurn will fit No modification to the trailer is required.